This angle steel roll former can produce metal steel corners 20x20mm, 25x25mm, 30x30mm, with a thickness of 0.3-0.6mm. This L-profile roll-forming machine runs at a speed of up to 70m/min.

The main component of the steel corner roll forming machine includes a hydraulic uncoiler, main roll forming machine, cutting machine, and cooling system.

1. Hydraulic uncoiler

• Capacity: 3 tons
• Coil ID: 470-530mm
• The hydraulic oil pump controls the mandrel's expansion and contraction.

2. Galvanized steel angle roll forming machine

• rolling stations: 10 rolling stations
• Shaft material is high-quality C45 steel. Through tempering treatment, the shaft diameter is 50mm.
• Roller material is Cr12 steel with quenched treatment, HRC 58-62, and final hard chroming.
• Main motor power: 15KW
• Transmission: by gearbox, ensure the L steel roll former can run stably
• Equipped with 1 set of water cooling system, cool down the rollers' temperature, reduce the abrasion of the rollers caused by high temperature.

3. The cutting part of the GI steel angle machine

• Cutting type: hydraulic fly cutting, driven by a servo motor, motor power 2.3KW
• cutting blade: Cr12 steel, quenched, HRC 58-62
• With 1 set of automatic oil lubrication system, drip oil on the linear guideway.
• The cutting power is supplied by a hydraulic oil pump; the motor power is 7.5KW.
• Equip 1 set of industrial air conditioners used to cool down the hydraulic oil temperature.

4. Runout table

Equip 1 set semi-automatic runout table and strapping machine. After cutting the steel angle, it will be transported to the runout table. The hydraulic oil cylinder pushes the steel angle, falls to the tables, then the worker stacks the steel angle manually and straps the bundle of steel angle.